Tubular Heat Exchanger Without Cover

DESIGN OF SHELL AND TUBE HEAT EXCHANGER - EPCM

• Introduction to Design of Shell and Tube Heat Exchanger Shell and Tube Exchangers - an overview ScienceDirect TopicsFigure 6.10 provides a look into the shell and tube exchanger. Contact between the cool and hot liquids will naturally exchange heat from the hotter to the colder. Figure 6.11 shows the Plan and Elevation views of a shell and tube exchanger.

  Shell and Tube Heat Exchangers Construction Details

  The shell-and-tube heat exchanger is named for its two major components round tubes mounted inside a cylindrical shell. The shell cylinder can be fabricated from rolled plate or from piping (up to 24 inch diameters). The tubes are thin-walled tubing produced specifically for use in heat exchangers. SHELL AND TUBE HEAT EXCHANGERS - thermopedia

  • 1. Shell and tube exchanger. The shell and tube exchanger consists of four major parts:Front Section 5.4 Shell and Tube Heat Exchanger CorrectedExample 5.2 Miniature Shell-and-Tube Heat Exchanger A miniature shell-and-tube heat exchanger is designed to cool engine oil in an engine with the engine coolant (50% ethylene glycol). The engine oil at a flow rate of 0.23 kg/s enters the exchanger at 120°C and leaves at 115°C. The 50% ethylene glycol at a rate of 0.47 kg/s enters at 90°C.

       Missing:

       • Cover Heat Exchanger Glossary - MechPro

       Bonnet Similar to a channel with straight tubes but without a removable cover. These do not have divider walls and are at each end of the heat exchanger. Bonnet Assembly Manages the tube side liquid for circulation through the tubes. This can also hold the tube side inlet and outlet connections and/or pass ribs.